Heat Pumps
Projects
  



A range of products to make day to day life more comfortable

Life without the luxury of hot water is almost unthinkable in this day and age. There is nothing more refreshing than an invigorating shower to overcome the tiredness of an early morning, and nothing is more relaxing than a long, hot bath.

With these simple factors in mind we aim to develop and produce water heating appliances and systems that guarantee the highest standards of hot water comfort. We offer products for every application and for all types of needs. Good looking products that utilise innovative technology to ensure comfort, efficiency and effectiveness are our trade mark.

Careful use of the Earth's natural resources is also very important to us, and we are fully aware of our responsibility to the Environment. Therefore we are constantly developing appliances and systems that use less and less water and energy. Some also utilise renewable energy sources, like ambient air and solar power. Recyclable and environmentally friendly materials are also used in the construction whenever possible.

You can count on the quality and reliability of a great brand name.





DHB-E Electronically Controlled Instantaneous Water Heater

Infinitely variable temperature selection, attractive design, many user functions and total reliability, characterize the electronically controlled instantaneous water heater DHB-E electronic. The desired water temperature is maintained right up to the point at which the output limit is reached.

With the electronically controlled heating output, problems due to pressure and flow rate fluctuations are a thing of the past. The DHB-E electronic guarantees your desired water temperature, up until the output limit is reached. It can be installed in combination with any approved plastic pipe systems and is suitable for both soft and hard water. The DHB-E electronic can be used to replace older models very easily.

The DHB-E electronic is very easy to use: The desired temperature can be selected by using the control knob to any temperature between 30 and 60 degrees. When the output limit is exceeded you simply reduce the water flow at the outlet and the desired water temperature is maintained.

· Always the exact water temperature that you desire, up to the output limit.
· Saving water and energy by means of electronic output adjustment
· Temperature selection by means of a control knob and temperature scale display
· Bare-wire heating system with pressurized copper cylinder
· ‘Profi-rapid’ installation technique



DHC Single Phase Instantaneous
Hot Water Unit

The Stiebel Eltron DHC is now available in Australia and even better it is the first single phase instantaneous hot water unit to be watermarked to Australian standards. The DHC is a compact, hydraulically controlled, pressure-type instantaneous water heater.

The size of the DHC allows it to be installed in areas where it would be impossible to install storage systems, and it can be installed virtually anywhere due to no safe tray or drainage (check local regulations) being necessary. The simplicity of this unit provides easy and cost effective installation.
The DHC saves energy as it only heats water as required and will continually heat the water as it passes through the unit. Being situated close to the points of use offers savings in time, energy and water by eleminating long lengths of pipe.




DHE Electronic Continuous Flow
Hot Water System

Dial up the temperature you desire, and never run out of hot water again. The DHE water heater provides all the benefits of an instantaneous hot water system with added comfort and control. Whether mounted under or above the sink, the DHE adapts to your specific needs in no time - just turn its casing and the control panel is within easy reach. Using an extra remote control, which can be supplied as an accessory, the desired water temperature can even be conveniently set from the kitchen.

With our new DHE appliance, constant hot water temperatures will pave the way into an energy-conscious future. Just set the temperature once and it will be kept exactly to the degree you have chosen - all the time and under all circumstance. How is this done? By gradually controlling the load of the heating elements and the flow rate.



DHF - 3 phs electric instantaneous water heater
For the replacement for existing three phase Hydraulically Controlled Instantaneous Water Heater
The DHF compact control hydraulically-controlled instantaneous water heater is very powerful, but it is also extremely small. The unit incorporates a two-stage hydraulic control which adjusts the heating output automatically depending on the water flow rate.

For small volumes of hot water the first stage energises, but if you require more hot water the second stage automatically energises. The unit can be permanently set at the second stage - if you wish so - by using the control knob on the front of the unit. An integral control valve helps to avoid any pressure fluctuations, which means that the water temperature remains virtually constant. The metal-sheathed heating element in a pressurized copper cylinder is most suited to soft water areas. The profi-rapid installation system ensures that installation is very simple.
  • 2-stage output control for increased economy
  • Permanent setting at higher output is possible by using the control knob
  • Most suitable for soft water areas
  • Can be used to replace of older models easily
  • ‘Profi-rapid’ installation system for simple installation
  



SN Compact "Point of Use" Water Heaters
The demands of hot water at a single outlet can be achieved very cost-effectively by an open-outlet water heater. The range of appliances include 5 or 10 litre, under or over sink heaters. Tap sets come complete with the under sink appliances. All are energy saving and cost effective when considering capital and installation.

Installation costs are kept to a minimum with the SN range of heaters. The open vented system does not require a relief valve, thus eliminating the need for overflow pipes. In addition, Australian Standard AS 3500 does not require 5 or 10 litre units to have a plumbed safety tray or relief valve.